Simons Voss Technologies Palm LDB Version 1.40 Manual de instalación descargar pdf (Pagina 185)

VdS Shunt lock function 3066

Page 10

Test the shunt lock function again after you have connected the lock switch contact.

Try to deactivate the locking cylinder or Smart Relay even when the bolts have not

been driven out.

• External light emitting diode

You can connect an external light emitting diode to soldering terminals 3 and 4 so that

you have a visual display in the outside area showing whether the cylinder or Smart

Relay is activated or deactivated. Maximum length of the line: 10 m (33 feet).

• Switch contacts (not used)

Soldering terminals 5 to 7 are not needed for the deactivation unit.

• Sabotage contacts

Connect these to soldering terminals 8 to 11. Solder the Rs resistor (terminating

resistor or short circuit) to soldering pins X27 and X28 (refer to the drawing).

Install other deactivation units, if any, according to the same plan.

2.2.3 Connecting Deactivation Request and Deactivation Acknowledgement

Refer to Chapter 2.5

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 218 219

Sin comentarios

Simons Voss Technologies Palm LDB Version 1.40 Manual de instalación Pagina 185