Simons Voss Technologies Palm LDB Version 1.40 Manual de instalación descargar pdf (Pagina 278)

LON – Network 3065

Page 16

5.3.2 Method of Operation

You need at least one LPI-10 for each network segment in order to supply the Lock-

Nodes.

The LPI-10 (new construction) has 3 terminals for connection to the supply voltage:

Terminals:

INPUT AC 230V:

L1: 230V~ connection

N: 230V~ connection

PE: Potential compensation connection

OUTPUT BUS:

NET+: Network cable connection

NET-: Network cable connection

BRIDGE 1 + 2:

- For a network with no topological

structure or with a star-shaped

structure, bridge the "Bridge 1-2" connection

- You are not permitted to bridge this connection if you are using a bus topology.

5.3.3 Assembly Instructions

The LPI-10 is intended

for installation in

distribution boxes with

DIN rails. Clamp the

voltage supplied from

outside to the

terminals marked for

that purpose.

Depending on the

structural situation and

number of groups, you

can also put several

power supplies and

routers in one

distribution box.

Connect the network cable

(twisted pair) here. For BUS

wiring, the connection

between "Bridge 1-2" stays

open, but for other wiring you

must insert a bridge here.

You can also lay a network

cable to the router (if there is

one). Connect the cable to

connecting terminals 17 and

18 there. An additional

network cable goes from the

router to the LockNodes.

Connect the outside

230V~ plug-in power

supply to these

terminals. This is

printed on the

connecting terminals.

Ground the LPI-10 on

the terminal labeled

PE.

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 317 318

Comentarios a estos manuales

Sin comentarios

Simons Voss Technologies Palm LDB Version 1.40 Manual de instalación Pagina 278

Comentarios a estos manuales

Relacionado con productos y manuales para No Simons Voss Technologies Palm LDB Version 1.40